With its power and easily transportable design, this compact and economical chipper is the ideal unit for utility line clearing, residential tree services, rental yards and municipalities. The Eeger Beever 1418’s 18″ (45.7 cm) diameter single top feed wheel with straight flow-through infeed design easily climbs over material, reduces drag and increases chipping efficiency, allowing it to overcome the limitations of comparable disc chippers.

Chipper Disc
37″ diameter x 2″ (93.98 cm x 5.08 cm) thick chipper disc material, ultrasonically tested and certified free of material defects, has four full-length, removeable paddles for maximum chip throwing velocity.

Infeed System
Folding infeed tray with single (top) feed wheel and straight, flowthrough infeed design for more efficient material feed.

Feed Wheel
TorqMaxTM Top Feed Wheel Compression system with spring assisted down pressure generates more than 3,200 lb/ft (4,338 Nm) of material pulling force.
General
Height: 8’2″ (2.49 m)
Width: 5’10” (1.78 m)
Length (transport): 16’7″ (5.05 m)
Length (operating): 17’3″ (5.26 m)
Gross weight (approximate): 5,350 lb (2,426 kg)
Suspension: 7,000 lb Torflex (3,175 kg)
Infeed opening: 33″ high x 60″ wide (83.8 cm x 152.4 cm)
Throat opening: 14″ high x 18″ wide (35.6 cm x 45.7 cm)
Disc dimensions: 2″ thick x 37″ diameter (5.1 cm x 94 cm)
Engine: CAT, Perkins, or PSI
Horsepower: 49–145 HP (36.5—108.1 kW)
Fuel capacity: 24.5 gallons (92.7 litre)
Hydraulic oil capacity: 9 gallons (34 litre)
Frame: 8.2 lb, 6″ (3.7 kg, 15.2 cm) channel
Tires: (2) 235/80Rx16
Hitch: 2.5″ Pintle (6.35 cm)
Equipment Highlights
Chipper disc with four staggered .5″ x 5″ x 7.25″ (1.27 cm x 12.7 cm x 18.41 cm) dual-edged knives and four full-length, bolt-on chip throwing paddles
Quarter disc hood access for disc maintenance and eases serviceability.
360° manual rotation discharge with adjustable chip deflector
Enclosed engine with gauge panel, radiator fines screen and slide rails for belt adjustment
Fuel tank sight gauge, drain plug and shutoff valve
Nine-gallon lockable hydraulic reservoir with sight gauge and clean-out door
Tube and support pad to mechanically raise and lower feed wheel using the drawbar jack
Options
- ChipSafe® Operator Safety Shield
- Reversing automatic feed system with hydraulic lift assist
- Winch package: heavy-duty, 5,000 lb (2,268 kg) pull capacity with rope and 10′ chafe guard
- Custom paint and logo packages
- Bottom Bump Bar
- Manual Crank Discharge
- Bottom Feedwheel
- Flow Control
- Axle Options Available
- Strobe Light
- Pusher Paddle
- Infeed Curtain

Morbark Knives: High Performance. Higher Value.
Morbark knives give you:
- Morbark Durability
- Improved Quality
- Better Value