2755 Flail Chiparvestor

Offering three-, four- or six-knife chipper disc options, the 2755 is ideal for some of your toughest jobs. A 27″ diameter chipping capacity and lift capacity of 17,200 lbs. at 10′ make the 2755 one of the toughest machines for any job. Customizable options include ESPAR heating system for cold weather starts, discharge spout extension to load open vans or rail cars, debris plow in lieu of telescoping conveyor, and remote control.

2355 Flail Hydrostatic Controls

Hydrostatic Controls

Flail drive is a closed loop hydraulic design with separate hydraulic systems to operate each flail drum. Each system is complete with electric tach and controls in operator’s cab.

2355 Flail Spreader Infeed

Spreader Infeed

This unique infeed system spreads multiple stems apart, which assists with more complete bark removal.

Chipper Disc

Chipper Disc

Each disc is fabricated from plate steel and put through ultrasonic testing. Material certification is issued for each disc, which provides the best chipper disc in the industry.

Chip Quality

Units produce quality chips even in non-merchantable and juvenile timber.

General

Length: 55’
Height: 13’6’’
Width: 11’11”


Gross weight: 120,960 lbs.
Tri- axle trailer: 75,000 lb. suspension


Engine: CAT or Cummins
Horsepower: up to 1050 HP


Drive (flail):  hydraulic
Drive (chipper): belt


Fuel capacity (tank): 500 gallons
Hydraulic oil capacity (feed systems and loader): 300 gallons
Hydraulic oil capacity (flail): 200 gallons


Cab and Loader

Cab offers operator a deluxe 6-way adjustable seat, joy stick controls, combination air conditioner/heater, and emergency shut-down system. Along with, complete engine gauge panel for both power units located in cab. Hydraulic tilt-down cab for transport. Morbark 500 knuckleboom loader, 23’ reach, 270º swing and 360º continuous rotation grapple. Lift capacity of 17,200 lb. at 10’


Flail

Infeed opening: 27” x 55”

Three top feed rollers mounted on yoke assemblies

Five stationary bottom feed rollers

Dual horizontal chain flails with patented segmented drums are equipped with eight flail chain rods

Discharge system consisting of 60-1/2” wide x 23’ long telescoping drag chain conveyor with hydraulic drive

Air curtain


Chipper

27” diameter chipping capacity

83” diameter chipper disc with a three, four or six-knife configuration

Chip sizes: 5/8”, 3/4”, 7/8”, or 1”

Dirt separator, bottom discharges onto 12” diameter twig augers

Hydraulic swivel/telescoping discharge spout


Options

  • Four- or six-knife chipper disc
  • Third flail drum
  • Dual engines
  • Reversing fan
  • 11-HP air compressor
  • Discharge spout extension to load open top vans or rail car
  • ESPAR heating system for cold weather start
  • Electric power option
  • Debris plow in lieu of telescoping conveyor
  • Halogen lights
  • Remote control
Specifications may vary with equipment options.
Bevel Buddy™ makes chipping more profitable

Bevel Buddy™ makes chipping more profitable

Re-sharpen knives without removing from machine for less downtime and more production!

You may also be interested in…