2455 Stand-Alone Flail

Whether used alone or in combination with a Morbark whole tree chipper to create a total fiber utilization system, the 2455 Stand-Alone Flail is built for maximized output. With three top feed rollers mounted on yoke assemblies, two stationary bottom feed rollers, and a bark discharge conveyor that folds for transport, this machine has many features perfect for whole tree chipping. The enclosed weatherized operator’s cab and color-tinted safety glass helps protect the operator.

2455 Flail Operator Controls

Hydrostatic Controls

Flail drive is a closed loop hydraulic design with separate hydraulic systems to operate each flail drum. Each system is complete with electric tach and controls in operator’s cab.

2455 Flail Infeed

Spreader Infeed

This unique infeed system spreads multiple stems apart, which assists with more complete bark removal.

Optional Cab & Loader

The enclosed operator’s cab includes six-way adjustable seat, joystick controls, combination air conditioner/heater and emergency shut-down system.

2455 Flail Grapple

Optional Grapple

Mor-Lift Model 500 Knuckleboom Loader has 23′ reach, 270-degree  swing and 17,200 lb. lift at 10′. Mor-Lift Model 1000 and foot pedal swing for loader also available.

General (4-flail option)

Length: 48’8″
Height: 14’5″
Width: 11’5″


Gross weight (with loader): 97,340 lbs.
Rear axle weight: 52,160 lbs.
Tongue weight: 45,180 lbs.


Engine: CAT or Cummins
Horsepower: 440- 700 HP
Electric powered units also available


Fuel capacity (tank): 240 gallons
Hydraulic oil capacity (flail): 200 gallons
(feed system & loader): 300 gallons


Tires: 11Rx22.5×16-ply radial

Brakes: air

Tandem axle or tri-axle trailer: fifth wheel


Infeed System

Heavy-duty spreader feed system with 24″ x 55″ infeed opening, consisting of three top feed rolls with synchronized feed rates, mounted on yoke assemblies. The center yoke assembly contains the top flail drum, which hydraulically raises for various diameter wood. Pinch points are 85″ from the back yoke wheel to the center yoke wheel and 85″ from center to the front yoke wheel. There are two stationary hydraulically driven bottom feed rolls and a 40″ wide x 8′ long outfeed conveyor.


MICS

MICS (Morbark Integrated Control System) monitors hydraulic pressures, temperatures,  engine parameters, controls auto-reversing fan functions, feed functions and allows utilization of remote diagnostic system.


Discharge

Discharge system consisting of 72″ wide x 23′ long telescoping drag chain conveyor with  hydraulic drive. Debris is bottom discharged into dual 12″ diameter twig augers.


Options

  • Two, three or four horizontal chain flail drums
  • Variety of feed wheel patterns
  • Light package
  • 30″ wide x 20′ long trough-type log conveyor
  • 11 HP air compressor with lockable enclosure
  • Radio and tethered remote control
  • Dead heel
Specifications may vary with equipment options.